Software update
7-6 Chapter 7: Maintenance and troubleshooting 98-127093-H
7.3.1 SBU software update
Preparing the software update
1. On the PC, unzip the zip file containing the new software. Remember or write down
which folder you extracted the file to.
2. Connect the SBU to the PC LAN port, using the SBU maintenance connector and a
straight LAN cable.
3. Power on the AVIATOR 200/300/350 system.
4. Open your browser and enter the IP address of the SBU. The standard IP address is
192.168.0.1.
If the local IP address of the SBU has been changed and you do not have the
new address, you can temporarily set the IP address to the default value by
pushing the Reset button next on the front plate of the SBU. For detailed
instructions see How to reset the IP address or the terminal software to
default settings on page 7-15.
For further information on the Reset button, see IP Reset (Default) button on
page 7-14.
For further information on IP addresses of the SBU see Set up the LAN IP
addressing on page 6-19.
You are now connected to the web interface of the SBU.
Note
Software update should only be done by qualified service personnel.
Note
SB-Lite.book Page 6 Tuesday, September 5, 2017 1:38 PM
To Next Page
Loading...
Need help?
General
