98-127093-H 7-1
Chapter 7
7777
Maintenance and troubleshooting 7
7.1 Continued Airworthiness
7.1.1 General
Maintenance
The AVIATOR system requires no periodic scheduled servicing tasks.
When replacing the TT-5040A SwiftBroadband Unit (SBU), it is important to
leave the TT-5040A-001 Configuration Module behind, attached to the airframe
with a wire.
Contact for support
AVIATOR 200/300/350 system purchased from a Cobham SATCOM distributor: If
you need assistance and you have purchased your system from a Cobham SATCO
M
distributor, contact the distributor’s support line.
AVIATOR 200/300/350 system purchased directly from Cobham SATCOM: If you
need assistance and you have purchased your system directly from Cobham SATCOM, you
can contact Cobham SATCOM by telephone or send an e-mail to the Cobham SATCOM
esupport.
Telephone numbers:
For urgent technical support please contact us at one of the following numbers:
• One Dial Phone: +45 39 88 89 89
• US, Virginia Beach office: +1 757 463 9557 or +1 866 SA
TCOMS.
The eSupport e-mail address is AVIATOR.support@cobham.com.
7.1.2 Instructions
Documentation
Maintenance information for the AVIATOR 200/300/350 System is contained in this
manual. Place the wiring diagram information in this manual in the aircraft operator's
appropriate aircraft wiring diagram manuals.
Inoperative units
If a system component is inoperative, remove or replace the unit.
If a level-D certified system detects an inconsistent hardware unit (level E) or
software image (level E), it enters failure mode and the system will not be
operational. Inconsistency messages are displayed to clearly inform the
service personnel about the reason for this failure mode.
Note
Important
SB-Lite.book Page 1 Tuesday, September 5, 2017 1:38 PM
To Next Page
Loading...
Need help?
General
