Administration
98-127093-H Chapter 6: Configuration of the AVIATOR 200/300/350 system 6-75
6666
6.7.3 Save and load a configuration
If you need to reuse a configuration in another SBU, you can save the current configuration
to a file, which can then be loaded into the other SBU. You can also use this feature for
backup purposes.
Configuration files can only be exchanged between SBUs with the same
software version!
Save a configuration to a file
The settings from the following pages of the web interface are saved in the configuration
file:
• SETTINGS
• ADMINISTRATION
• PHONE BOOK
To save your current configuration to a file, do as follows:
1. In the ADMINISTRA
TION page, under Configuration, click Save.
Figure 6-58: Web interface: Administration, saving a configuration file
2. Accept the default destination file name or type in the destination file name and
location.
3. Click OK. The configuration is now saved to a file. This file is used to load the
configuration into another SBU.
Note
SB-Lite.book Page 75 Tuesday, September 5, 2017 1:38 PM
To Next Page
Loading...
Need help?
General
