AVIATOR 200/300/350 system components
98-127093-H Appendix A: Equipment specifications A-5
AAAA
A.2.4 TT-5040A-004 WLAN antenna
A.2.5 TT-5038A-003 Rx Power Splitter
Characteristics Specification
Dimensions (L x W x H) 12 mm x 119 mm x 13 mm (0.48” x 4.7” x 0.5”)
Weight 28.3 g (1 ounce)
Mounting
For mounting instructions for WLAN antennas see Figure 5-
2: Mounting two WLAN antennas for optimum performance in
TT-5040A-004 WLAN antennas on page 5-7.
Connector Male TNC
Operating Temperature
Ground Survival
Temperature
-40 C to +71 C
-55 C to +85 C
Altitude Pressurized (Cat. A1): 15,000 ft
Decompression (Cat. A1): 45,000 ft
Overpressure (Cat. A1): -15,000 ft
Relative humidity 95% non-condensing at +50°C
Cable type Plenum, RG-316U coaxial
Cable length (including
connector)
7.5” ± 0.25” (190.5 ±6.4 mm)
Table A-4: Equipment specifications for WLAN antenna
Characteristics Specification
Dimensions
(L x W x H)
86.8 mm x 50.8 mm x 19.1 mm
(3.42” x 2.00” x 0.75”)
including connectors.
Weight 146 g ±10 g (0.32 lbs ±0.02 lbs)
Mounting If the Rx Power Splitter is to be mounted on a flat surface, mount it on a 3
mm mounting plate to provide enough space for mounting of the
connectors.
Can be mounted in an unpressurized but temperature controlled location.
Connectors 3 x N-connector, Female.
Built-in DC-block on the HSU (SBU) port.
Table A-5: General specifications for Rx Power Splitter
SB-Lite.book Page 5 Tuesday, September 5, 2017 1:38 PM
To Next Page
Loading...
Need help?
General
