Chapter 3: Operation
98-148232-E To access the terminal from a remote location 31
• _IUPDFW Update the terminal with new firmware.
See Remote software upgrade on page 42.
• _ISENDFILE Send a file from the terminal to an FTP server.
See File transfer on page 43.
• _IGETFILE Retrieve a file from an FTP server to the terminal.
See File transfer on page 43.
• _IUPDCFG Update to a new configuration file.
See File transfer on page 43.
• _IREMWEB Open a connection for remote access to the terminal’s Web interface.
See Remote access to the web interface on page 31.
• _ICPWD Change the terminal’s admin password.
See Security setup on page 34.
• _IATCROBST Configure 3GGP LTE robustness feature.
Remote access with AT commands
Access the terminal as described in To access the terminal using AT commands on page 24.
You must use the global IP address of the EXPLORER 540.
Remote access to the web interface
There are two methods of getting remote access to the web interface:
• Using the AT command _IREMWEB, e.g. sent in an SMS (ATCO command).
• Using an EXPLORER 540 that is pre-configured with trusted IP addresses.
The following sections describe these two methods.
To use AT commands to get remote access to the web interface
You can send the AT commands encapsulated in an SMS (ATCO commands). For details, see
Remote access with SMS on page 25.
Relevant commands:
_IREMWEB
See ATCO commands on page 133 for syntax and parameters.
When using remote access, the web interface may take a long time to load the pages,
because the Internet connection may be slow.
Only one PDP context at a time can be used for remote web interface access.
If remote SMS command access has been disabled, you can enable it either using the
web interface or using AT commands. See To set up remote access with SMS on
page 86 and To set up the security with AT commands on page 34 (step 4.).
To Next Page
Loading...
