Replay function
98-171832-A Chapter 2: Operation 37
Replay function
Replay allows the operator to playback received voice messages in the
loudspeaker. Recording is activated automatically when a chosen channel
becomes active. Recording is not possible during playback. Up to 60 tracks or
480 seconds can be handled. During a power cycle the recorded tracks are
deleted.
The recorded channel is displayed. The message length is shown in seconds. The
display shows how old the message is. If the 480 seconds storage limit is
reached, the oldest data is overwritten.
Replaying recorded messages
From the idle screen. tap the REPLAY button.
The latest message is repeated. Information about this message is shown in the
display.
To stop replaying the message, tap STOP.
To rewind through the recorded messages tap REWIND.
If a signal is received while in replay mode the display shows RX at the top. You
can now select whether to exit replay and listen to the active channel or wait for
the channel to become inactive and then replay the latest track.
The replay function can be started even in a distress situation. If a
DSC call is received the replay function continues the playback.
Acknowledgment of the DSC call immediately initiates and
activates the DSC session. You can initiate replay again from any
session afterwards.
To Next Page
Loading...
Need help?
General
