COBHAM SAILOR 7224 - About; Remote Control; To Connect to the Control Unit after Activating

Settings
98-171832-A Chapter 2: Operation 51
REMOTE CONTROL
When you activate Remote control, you can access the graphical user interface
from any unit with a browser installed.
To connect to the Control Unit after activating, do as follows:
1. Connect your device to one of the LAN connectors on the SAILOR 7224
Control Unit
2. Open your browser and type http://<CU IP>, where <CU IP> is the IP address
of the Control Unit.
The web interface now opens and lets you control the system from your
connected device instead of on the Control Unit display.
ABOUT
Note
If you access any of the controls on the physical Control Unit while
remote control is used, the remote control is deactivated and you
have to activate it again to be able to use it.
Parameter Description
ACTIVATE Opens the API and GUI for access through external LAN ports.
A popup shows connection status and a button for
deactivating.
Parameter Description (read only)
CONTROL UNIT
• Serial number
• Hardware Tracking Number
•Software version
TRANSCEIVER
UNIT
• Serial number
• Hardware Tracking Number
•Software version
APPROVALS List of approvals, e.g. FCC
LICENSES List of licenses, e.g. GPL