Settings
40 Chapter 2: Operation 98-171832-A
RADIO
Parameter Description
SCAN HANG
TIME
Scan hang time, in seconds on an active receiving working channel.
The time is measured from the signal is detected. The radio
remains on the channel for the set time interval, if a signal was
detected.
OFF: Resumes scanning when signal disappears (default)
4, 6, 8, 10: Hang time in seconds.
SCAN
RESUME
TIME
Scan resume time, in seconds. When the programmed time of
inactivity has elapsed, and when watch/scan has been aborted
using a push on PTT, or after power-up, scan or watch is resumed.
OFF: Automatic resume is deactivated (default)
3, 6, 10, 15, 20, 25, 30: Resume time in seconds.
PRIORITY
SCAN
ON: All channels tagged for scanning are scanned while monitoring
channel 16. (default).
OFF: Only the channels tagged for scanning are scanned in
sequence, not channel 16, unless it is tagged for scanning.
ATIS CODE 10 digit numerical (Default: not set, password protected if set)
The ATIS code is used for identification to marine coast and inland
stations and its use is mandatory in a number of European inland
waterways. The ATIS number is issued by the relevant authority.
For ships coming from states which are not member of the
Regional Arrangement, the ATIS-Code is based on the MMSI with a
9 as the first digit.
a
a. The Committee RAINWAT in its 12. Meeting (October 2008) decided to change
the building rules of the ATIS code for vessels coming from a country outside
the RAINWAT arrangement.
To Next Page
Loading...
Need help?
General
