Code Corporation Code Reader 3.0 - Continous Scan Settings; Continous Scan - Sleep Time out; Continous Scan - Trigger Delays; Continous Scan - Duplicate Scan Delay

C002332_02_CR3 User Manual - 31
Save Settings
2.11.1 - Continous Scan - Sleep Time Out
Scan one of the codes below to set the amount of time a cabled CR2 will operate in continous scan mode
before entering sleep mode:
Cabled - 2 hours Cabled - Always (Default)
Scan one of the codes below to set the amount of time a uncabled CR2 will operate in continous scan
mode before entering sleep mode:
Uncabled - 5 minutes (Default) Uncabled - 15 Minutes Uncabled - 30 Minutes
Note: This function is only reccommended for short term use because of battery consumption.
2.11.2 - Continous Scan - Trigger Delays
Scan the following codes to set delay time between scans:
0 Seconds (Default) 1 Second 3 Seconds
2.11.3 - Continous Scan - Duplicate Scan Delay
Scan the following codes to set the delay time for reading duplicate codes:
0 Seconds (Default) 1 Second 3 Seconds
2.11 - Continous Scan Settings
2.12 - Motion Detection Scan Settings
Scan the following code to set the reader to read when it detects motion in its scanning zone.