C002332_02_CR3 User Manual - 16
Save Settings
Save Settings
Scan the code below to make the RF settings permanent on the reader:
Save Settings
Disconnecting from the Device
You may force disconnection by reading the disconnect code below (The CR3 may not appear
disconnected in the slave Bluetooth connection manager for 10 – 15 seconds after the command is
issued). The CR3 will also disconnect after 90 seconds of inactivity (Note: You may change the radio
frequency sleep time out setting however, it may reduce battery life).
Bluetooth Disconnect
Reconnecting to the Device
If the device is saved in RF mode it will automatically reconnect when:
1. CR3 is powered up
2. CR3 wakes from sleep mode
3. CR3 reads another code
Note: To set up more than one device, please consult Appendix F: “QuickConnect Codes”
1.7.2 - Bluetooth Radio Auto Connect
Auto Connect: After coming out of sleep mode or after powering up (need to save the connection) the
CR3 tries to auto connect with the last Bluetooth radio it was connected with. You may always connect
by scanning a QuickConnect code.
Scan the following codes to enable or disable Auto Connect feature for the Bluetooth radio:
Bluetooth Radio Auto Connect On (Default) Bluetooth Radio Auto Connect Off
To Next Page
Loading...