C002332_02_CR3 User Manual - 46
Save Settings
4.4 - Backlight Timeout Settings
4.5 - Laser Settings
Scan one of the following codes to set the brightness of the CR3 laser.
High (Default) Medium Low
Scan the following codes to turn laser targeting on/off:
On (Default) Off
Scan the following codes to set the backlight settings:
Backlight Off 3 seconds (Default) 6 seconds 10 seconds
4.6 - Reader Power Off Settings
Scan the following codes to set the amount of time before a reader powers down:
1 Hour 2 Hours - Default 4 Hours
Press and hold (1 second) any red trigger on the reader to power up a unit.
To Next Page
Loading...