MINI_1000_en.pdf http://www.codelight.com
31
6.4.2.4. Fixture Overlap
The [Fixture Overlap] allows you to run a series of fixtures with chasing effect in one
step. The range of overlap is from 0%~100%.
When overlap=100%, all fixtures will change together. If overlap=50%, the second
fixture will not start until the first fixture is half way (50%) through fading. The fixtures
running order follows to the setting of fixture order.
The running time will be divided equally for each fixture. That means, if there are 5 pieces
of fixtures run in 10 second for the step. After set the fixture overlap, each fixture uses 2
seconds to finish its effect.
6.4.2.5. Fixture Order
The [Fixture Order] in cue-lists
should run with Fixture Overlap or effect.
You can not find the effects if you did not
setup fixture overlap or effect in advance.
The way of setup Fixture Order please
refers to chapter 3.3.2.
However, you may close some of
fixtures if you don’t want them run with
fixture overlap. The closed fixture(s) will
start to run as soon as the first fixture(s)
begin, and finish at the same time as last
fixture(s) ended.
②
①
③
To Next Page
Loading...
Need help?
Power
Weight and Dimensions
