ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
52
5.2 Controller configuration and PC tools
connection
5.2.1 USB 52
5.2.2 RS232/RS485 53
5.2.3 Ethernet 54
6 back to Controller setup
This chapter contains brief introduction into the specifics of firmware and archive upload and connection of
various PC tools to the controller. If you require detailed information on each PC tool please use the included
Help in those PC tools or download their Reference Guides.
5.2.1 USB
You may connect to the controller using the USB port. In this case standard USB A to B cable should be used.
Connection using InteliConfig
Image 5.1 First screen of InteliConfig - select connect to controller
Image 5.2 Second screen of InteliConfig - select detected controllers

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65