ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
9
IMPORTANT: Be aware that the binary outputs can change state during and after software
reprogramming (before the controller is used again ensure that the proper configuration and
setpoint settings are set in the controller).
The following instructions are for qualified personnel only. To avoid personal injury do not perform any action not
specified in related guides for product.
1.5 Certifications and standards
EN 61000-6-2
EN 61000-6-4
EN 61010-1
EN 60068-2-1 (-20 °C/16 h for std, -40 °C/16 h for LT version)
EN 60068-2-2 (70 °C/16 h)
EN 60068-2-6 (2÷25 Hz / ±1,6 mm; 25÷100 Hz / 4,0 g)
EN 60068-2-27 (a=500 m/s
2
; T=6 ms)
EN 60068-2-30:2005 25/55°C, RH 95%, 48hours
EN 60529 (front panel IP65, back side IP20)
1.6 Document history
Revision number Related sw. version Date Author
11 1.9.0 23.9.2019 Michal Slavata
10 1.8.0 21.5.2019 Michal Slavata
9 1.7.0 22.8.2018 Michal Slavata
8 1.7.0 4.7.2018 Michal Slavata
7 1.6.0 28.2.2018 Michal Slavata
6 1.5.0 9.10.2017 Michal Slavata
5 1.3.2 24.5.2017 Michal Slavata
4 1.2.1 5.12.2016 Michal Slavata
3 1.1.0 23.5.2016 Michal Slavata
2 1.1.0 6.3.2016 Michal Slavata
1 1.0.0 15.7.2016 Michal Slavata

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65