ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
82
Note: Use Up and
down button to
select required
language.
Note: Use Enter button to confirm selected language.
5.3.7 Display contrast adjustment
+
Note: On any measurement screen press Enter and
Down button together for lower contrast.
+
Note: On any measurement screen press Enter and
Up button together for higher contrast.
Note: After setting a contrast, no another action is needed.
6 back to Controller setup
5.4 Remote Display
This chapter describes Remote display firmware IL3-RD, which is designed as a remote signaling and control
software for InteliLite family controllers. It is the optional software which is possible to upload into controller
instead of standard controller’s firmware.

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65