PROGRAM MODULES
Once you have nished con guring the system modules according to the instructions provided in the chapter “TREE MENU
SCREEN AND MODULE PROGRAMMING” and the system is capable of communicating with the PC via the SIMPLEHOME/
RS232 interface, this command can be used to transfer programming to the system.
AVAILABLE COMMANDS
Send programming to the installed system
Exit the "PROGRAM MODULES" function without transmission and return to the main screen
Select the serial number from which to begin programming
Select the nal serial number for programming
N.B. it is always possible, using this command, to send new programming to a system already con gured on a previous occasion: in this case
the previous programming will be overwritten by the recently transmitted data.
57
To Next Page
Loading...