Comelit simplehome - Serial Bridge Art. 20090334

2.22 - SERIAL BRIDGE ART. 20090334
The Serial Bridge module makes it possible to communicate with the SimpleHome home automation BUS and the SimpleSafe anti-intrusion system.
It can be used as follows:
• weekly schedule programmer: sends commands to outputs, zones, scenarios and thermostats within the system.
• link in/out management: links an alarm control panel event (area status or input status) to an event for transmission over the home
automation BUS (modules, zones, scenarios, etc...).
• rule management: programs 3-element rules with AND/OR functions between inputs, outputs or security/home automation timer in
order to generate an event.
• scenario management: can program scenarios which include procedures for transmission to the SimpleSafe security system and/or the
SimpleHome home automation system.
User setup and management must take place via the WEB interface.
Technical characteristics
The Serial Bridge is a Web Server device which, by means of a PC browser, tablet, smartphone, etc... is able to do the following without the installation
of any additional programs:
Display/Control 8 areas of a compatible alarm control unit.
48 lights over BUS.
24 sockets over BUS.
24 timed outputs or shutter.
24 analogue inputs, which may be:
• 20046707 modules confi gured as thermostat with temperature sensor connected.
• thermostats and temperature sensors on the BUS.
Display the status of the fi rst 80 wired inputs of a compatible control unit.
the status of the fi rst 48 radio inputs of a compatible control unit.
8 load modules by consumption/production.
Control the 16 scenarios set on the device.
From the Serial Bridge it is possible to confi gure:
up to 32 timers.
up to 32 commands sent over the link between the alarm control unit and the SimpleSafe BUS.
up to 32 rules with 3 elements each.
up to 32 scenario commands with 20 elements each.
46