Compaq ProLiant 3000 User Manual

3-58 Diagnostic Tools
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Continued
Pager Data Setting Description
Network IP
address
N/A Enter the IP address for this server in standard dot notation.
NOTE: This is not used if you select Custom for Network controller. You must
enter your IP address in the NET. CFG file that you load into the system
partition.
Network IP net
mask
N/A Enter the net mask for this server in standard dot notation.
NOTE: This is not used if you select Custom for network controller. You must
enter your IP address in the NET. CFG file that you load into the system
partition.
Network IP
router address
N/A Enter the router to be used for this server in standard dot notation.
NOTE: This is not used if you select Custom for network controller. You must
enter your IP address in the NET. CFG file that you load into the system
partition.
If you configure the server to boot into Compaq Utilities, it prepares for remote
communications. You can remotely run Diagnostics software, the Inspect Utility, or the System
Configuration Utility using a workstation running terminal emulation software, such as Compaq
Insight Manager or PC Anywhere.
Booting into the Operating System
When you enable ASR-2 to restart into the operating system and a critical error occurs, ASR-2
logs the error in the Critical Error Log or IML and restarts the server. The system ROM pages
the designated administrator, then executes the normal restart process.
IMPORTANT: When you enable ASR-2 to restart into the operating system, Modem Dial-In
Status, Network Status, and Modem Dial-Out Status are automatically disabled. In this
mode, ASR-2 can page you if a critical error
occurs, but you cannot access the server, and
the server cannot dial out to a remote workstation.
If the ASR-2 feature cannot restart the server within 10 attempts, it logs a critical error in the
Critical Error Log or IML Log restarts the server into the Compaq Utilities, and puts the modem
into auto-answer mode.
Your System Configuration Utility setting should resemble the following when you enable ASR
to restart into the operating system:
■ Serial interface COM1
■ Dial-in status Disabled
■ Dial-out status Disabled
■ Dial-out string 555-1234
■ Network status Disabled
■ Network protocol IPX

Compaq ProLiant 3000 Specifications

General

Brand	Compaq
Model	ProLiant 3000
Category	Server
Language	English