3-34 Diagnostic Tools
Pointing Device Interface Test Error Codes
The 8600 Diagnostic error codes identifies failures with the pointing device (mouse, trackball,
and so on) or the system board assembly.
Table 3-20
Pointing Device Interface Test Error Codes
Error Code Description Recommended Action
8601-xx Pointing Device Interface test failed. 1. Replace with a working pointing device and
retest.
2. Replace the system board and retest.
Drive Array Advanced Diagnostics (DAAD)
Drive Array Advanced Diagnostics (DAAD) is a DOS-based tool designed to run on all Compaq
products that contain a Compaq Drive Array Controller. The error messages and codes listed
include all codes generated by Compaq products. Your system generates only codes applicable
to your configuration and options.
The two main functions of DAAD are:
■ Collecting all possible information about array controllers in the system
■ Offering a list of all detected problems
NOTE: Refer to the
Drive Array Advanced Diagnostics User Guide,
found on the SmartStart and
Support Software CD
,
for complete details and procedures about this diagnostic tool.
DAAD works by issuing multiple commands to the array controllers to determine if a problem
exists. This data can then be saved to a file and, in severe situations, this file can be sent to
Compaq for analysis. In most cases, DAAD provides enough information to initiate problem
resolution immediately.
NOTE: DAAD does not write to the drives or destroy data. It does not change or remove
configuration information.
To Next Page
Loading...
Need help?
General
