Compaq ProLiant 3000 - Page 160

I
nde
x
-14
ROMPaq
Firmware Upgrade Utility, accessing 3-2, 3-3
ROM upgrade procedure 3-65
S
SCSI
cable folding and routing, illustrated 2-29
Duplex Hot-Plug Drive Cage, part number 1-5
Simplex Hot-Plug drive cage, part number 1-3
tape drive, test error codes 3-32
SCSI hard drive, test error codes 3-31
SDRAM See DIMMs
security, ASR-2 3-59
serial, test error codes 3-24
server
health logs 3-59
recovery
attended 3-51
automatic 3-50
automatic, after failure 3-51
from software error 3-51
unattended 3-51
remote management features, defined 3-64
remote service features, defined 3-64
Server Manager/R board, test error codes 3-32
server warnings 2-4
servicing unit, preparation procedures 2-2
shipping materials, part number 1-4
side access panel
part number 1-3
removing 2-12
removing, illustrated 2-12
replacing 2-12
Simplex cage, location 2-19
Simplex Enabler board
removing 2-21
removing, illustrated 2-21
replacing 2-21
Simplex Hot-Plug drive cage, part number 1-3
Simplex to Duplex conversion 2-21
slot card guide, part number 1-4
slot cover, part number 1-4
Smart Array 3200 Controller
part number 1-5
removing 2-33
SmartStart and Support Software CD-ROM, running
utilities 3-2
software error, recovery from 3-51
spare parts, description 1-3
specifications
CD-ROM drive 5-6
diskette drive 5-5
hard drive, hot-plug 5-9, 5-10, 5-11, 5-12
operating 5-1
optional hardware 5-1
performance 5-1
physical 5-1
power supply 5-3
system unit 5-2
storage automatic reconstruction, defined 3-63
storage fault recovery tracking, defined 3-63
switches
diskette boot feature, settings 4-3
lock configuration, settings 4-3
maintenance, settings 4-3
power
removing 2-42
removing, illustrated 2-42
replacing 2-42
power-on password, settings 4-3
processor, settings 4-5
rack-to-tower conversion, settings 4-3
system I/O board configuration, settings 4-3
video, settings 4-3
switchessystemI/Oboardconfiguration,illustrated
4-3
symbols
definitions vii
examples vii
used in equipment 2-2
used in text vii
system components, exploded view 1-2
System Configuration Utility
executing 3-3
System Configuration Utility, accessing 3-2, 3-3
System Configuration Utility, main menu 3-17
system I/O board
configuration switch, illustrated 4-3
configuration switch, settings 4-3
connector location 4-1
connectors, illustrated 4-2
removing 2-41
removing, illustrated 2-41
replacing 2-41
w/subpan, part number 1-3
system unit
dimensions 5-2
specifications 5-2
weight 5-2