EasyManua.ls Logo

Compaq ProLiant 3000 - Page 62

Compaq ProLiant 3000
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-5
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
POST Error Messages
Continued
Error Code
Audible Beeps
L=Long S=Short
Probable Source of Problem
Recommended Action
162-System Options
Not Set
2S Configuration incorrect. Run the System Configuration Utility
and correct.
163-Time & Date
Not Set
2S Invalid time or date in
configuration memory.
Run the System Configuration Utility
and correct.
170-Expansion
Device Not
Responding
None EISA or PCI expansion board
failure.
Check board for secure installation.
Replace the failed board if necessary.
172-Configuration
Nonvolatile Memory
Invalid
None Nonvolatile configuration
corrupt or jumper installed.
Run the System Configuration Utility
and correct.
172-1 Configuration
Nonvolatile Memory
Invalid
None Nonvolatile configuration
corrupt.
Run the System Configuration Utility
and correct.
172-2 IRC
Configuration Invalid
None IRC enabled and video
controller is in PCI slot on the
secondary bus.
Move video controller to a PCI slot on
the primary PCI bus.
173-Slot ID
Mismatch
None Board replaced, configuration
not updated.
Run the System Configuration Utility
and correct.
174-
Configuration/Slot
Mismatch Device
Not Found
None EISA or PCI board not found. Run the System Configuration Utility
and correct.
175-
Configuration/Slot
Mismatch Device
Found
None EISA or PCI board added,
configuration not updated.
Run the System Configuration Utility
and correct.
176-Slot with Not
Readable ID Yields
Valid ID
None EISA or PCI board in slot that
should contain an ISA board.
Run the System Configuration Utility
and correct.
177-Configuration
Not Complete
None Incomplete System
Configuration.
Run the System Configuration Utility
and correct.
178-Processor
Configuration Invalid
None Processor type or step does not
match configuration memory.
Run the System Configuration Utility
and correct.
179-System
Revision Mismatch
None A board was installed that has a
different revision date.
Run the System Configuration Utility
and correct.
180-Log Reinitialized None N/A N/A
Continued

Table of Contents

Other manuals for Compaq ProLiant 3000

Related product manuals