To Next PageTo Next Page
Need help?Do you have a question about the Comtech EF Data CDM-570L and is the answer not in the manual?
Allows configuration of various modem parameters including Remote Control, Transmit, Receive, Frame, Interface, Reference, Mask, and ODU.
Accesses various test modes and loopbacks for unit verification and diagnostics like IF Loopback and Digital Loopback.
Describes the available IP Module working modes (easyConnect™, Router) and HDLC addressing modes for network optimization.
Accesses administrative settings including Name/Password, Access Lists, and Feature Configuration.
Defines how IP packets are routed based on destination, next hop, and interface settings.
Provides access to unit uptime, software information, boot settings, and system maintenance functions.
Guides through configuring a pair of CDM-IP modems for easyConnect™ Point-to-Point operation.
Guides through setting up a Point-to-Point system in Router Mode with static routes and HDLC addresses.
General| Interface | Ethernet, Serial |
|---|---|
| IF Frequency | 70 MHz, 140 MHz |
| Power Supply | 100 - 240 VAC, 50/60 Hz |
| Modulation | QPSK, 8PSK |
| FEC | Viterbi, Reed-Solomon |
| Data Interfaces | Ethernet, RS-232, RS-422 |
| Symbol Rate | up to 30 Msps |
| Operating Temperature | 0°C to +50°C |
| Dimensions | 1.75" H x 19" W x 16" D |
