Comtech EF Data CDM-570L - Page 21

Page 15 of 54 MN/CDM570L.AA4
17
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Trasnmit DES
enable/disable
TDE= 1 byte, value
of 0, 1, 2 or 3
Command or Query where,
0=Disabled
1= Enabled (EasyConnect Only mode)
2= PerRoute (read-only when FAST feature is purchased in router
mode)
3 = Unavailable (read-only when FAST feature not purchased)
Acts as command, only in EasyConnect mode. In router mode, it’s
read-only.
Enables or disables the Transmit 3xDES feature.
Restriction: Can not enable if the 3xDES FAST feature has not
been purchased
TDE =
TDE!
TDE? TDE =x
(see description of
arguments)
TX Header
Compression
enable/disable
THE= 1 byte, value
of 0, 1, 2 or 3
Command or Query where,
0=Disabled
1= Enabled (EasyConnect Only mode)
2 = PerRoute (read-only when FAST feature is purchased in router
mode)
3 = Unavailable (read-only when FAST feature not purchased)
Acts as command, only in EasyConnect mode. In router mode, it’s
read-only.
Enables or disables the Transmit 3xDES feature.
Restriction: Can not enable if the 3xDES FAST feature has not
been purchased
THE =
THE!
THE? THE =x
(see description of
arguments)
RX Header
Compression
enable/disable
RHE= 1 byte, value
of 0, 1, 2 or 3
Command or Query where,
0=Disabled
1= Enabled
Enables or disables the Transmit 3xDES feature.
Restriction: Can not enable if the 3xDES FAST feature has not
been purchased
RHE =
RHE!
RHE? RHE =x
(see description of
arguments)