Page 15 of 54 MN/CDM570L.AA4
29
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
IGMP Client:
Version
ICV 1 byte, 0 or 1 Command or Query
where,
Set the IGMP Version for Unsolicited Reports.
0=V1
1= V2
Recognize IGMP Queries
Example: ICV =0
ICV =
ICV!
ICV?
ICV =xxx
(see description of
arguments)
IGMP Client:
Unsolicated
Report
Internval
IRI= 2 bytes 0..25 Command or Query
where,
Set the unsolicited Report Interval [Modem as Client]
Range = 1..25
Example: <1/IRI =14
IRI =
IRI!
IRI? IRI =xxx
(see description of
arguments)
IGMP View
Table
None String value Query only.
Display the IGMP table with different states. To see the entries, the
system should have the IGMP feature enabled, and should be
properly configured to forward IGMP packets. See WEB interface
for proper table format.
Note: Not yet supported in 1.5.3 Release. Will available in next
release.
IGT=
IGT!
IGT? IGT=sssssss
Table of IP Addresses
and their state
information.
To Next Page
Loading...
