4. BIOS Setup
User’s Manual
39
Parallel port : This setting is for PRINTER on the
equipment connector plane.
When the port is set to "Enable," it
defaults to the following:
Mode [ECP]
Base I/O address [378]
Interrupt [IRQ7]
DMA channel [DMA3]
Items to be set Enable:
Manually set the base I/O address and
IRQ. The IRQ you set here must be set
to Available in the PCI Configuration
window. (See the Note below).
Auto:
Automatically set by the BIOS. Enabled
once the BIOS is started.
OS Controlled:
Automatically set by the OS. Remains
disabled until the PnP OS is started.
Mode*:
Set to parallel port's operating mode.
DMA channel*:
This is the DMA channel setting used
when ECP is selected during parallel-
port mode setting.
* A menu exclusive to the parallel port.
To Next Page
Loading...
