4. BIOS Setup
40 User’s Manual
Note!
If the following message appears on booting when serial port D or
the parallel port are set to “Enable”, this indicates a resource
(IRQ) conflict or similar BIOS problem.
Error
0615: Com D configuration changed
In this case, enter the setup menu again and change the IRQ from
“Reserved” to “Available” or modify the settings if an interrupt
conflict occurs.
* Serial port D: [Enable]
←
An asterisk (*) is displayed
Base I/O address: [2E8]
Interrupt: [IRQ5]
→
Set to “Available” in the PCI
Configuration window.
PCI/PnP ISA Reserve Exclusion
* IRQ5: [Reserved] → Change to [Available].
To Next Page
