Genus G2 User Manual
UM3000-1
Revision E November 2017 25
6. Press to highlight the Length Qualifier field.
7. Press to highlight a Length Qualifier.
Length Qualifier options include = (equal) or <= (less than or equal).
8. Press to highlight the Length field.
The Terminal accepts up to 32 characters in the length field.
9. Use to delete the field and use the numeric keypad to enter a new value.
10. Press to scroll through the remainder of the fields and select up to five barcode
formats for testing.
11. To cancel changes, press to advance to and highlight Cancel .
12. Press to cancel and return to the Main Reader Setup screen.
13. To accept changes, press to advance to and highlight Apply .
14. Press to apply your changes and return to the Main Reader Setup screen.
15. On the Main Reader Setup screen (0, 1, 2), press to advance and highlight Apply
and press to save settings.
16. Press to return to Main Menu at the bottom of the screen.
Note: When the Barcode reader is tested while in Offline Mode, the data will be visible below the
“Swipe badge to test reader” prompt.
To Next Page
Loading...
