Genus G2 User Manual
UM3000-1
Revision E November 2017 27
Biometric Reader Setup
1. Press to advance to and highlight Enable Biometric Reader.
2. Press to check for Enable or uncheck for Disable Biometric Reader.
3. Once Enable Biometric Reader is checked, press to setup a biometric reader. Loading
Biometric Information will display followed by Biometrics Setup.
Press Enter to test the reader. Then following instructions for confirming enrollment, verifying,
and/or deleting. The enrollment occurs for badge number ‘1’. If someone is already
enrolled under that ID, the templates will be erased.
Note: The Com4 setting is the Biometric reader default and should remain as is.
Messages from firmware tests on the Biometric reader, calibration attempts, and com port
configurations are displayed under the Configured Com Port section of the screen.
To Next Page
Loading...