CP Plus Orange - Page 171

⚫ Figure 1-194
⚫ Step 4 Configure the settings for the system maintenance parameters. See Table 1-52.
⚫ Table 1-52
Parameter
Description
Auto Reboot
In the Auto Reboot list, select the reboot time.
Case Fan Mode
In the Case Fan Mode list, you can select Always run or Auto. If you
select Auto, the case fan will stop or start according to the external
conditions such as the Device temperature.
This function is for some series products only, and it is only
supported on the local configuration interface.
⚫ Step 5 Click Apply to complete the settings.
⚫
1.10.4.2 IMP/EXP
⚫ You can export or import the Device system settings if there are several Devices that require the same
setup.
⚫ The IMP/EXP interface cannot be opened if the backup operation is ongoing on the other interfaces.