This is the interval that the system sends an email for the same
type of alarm event, which means, the system does not send an
email upon any alarm event.
This setting helps to avoid the large amount of emails caused by
frequent alarm events.
The value ranges from 0 to 3600. 0 means that there is no interval.
Enable the health test function. The system can send a test email
to check the connection.
This is the interval that the system sends a health test email.
The value ranges from 30 to 1440. 0 means that there is no
interval.
Click Test to test the email sending function. If the configuration is
correct, the receiver’s email account will receive the email.
Before testing, click Apply to save the settings.
⚫ Step 3 Click Apply to complete the settings.
To Next Page
Loading...
