to call.
⚫ Step 2 Click to call the tour.
⚫ Step 3 Click again to stop calling the tour.
1.4.4.3 Calling Patterns
⚫ Step 1 On the Expanded PTZ Control Panel, in the No. box, enter the value of the pattern that you
want to call.
⚫ Step 2 Call to call the pattern.
⚫ The PTZ camera moves according to the configured pattern repeatedly.
⚫ Step 3 Click again to stop calling the pattern.
1.4.4.4 Calling Auto-Scan
⚫ Step 1 On the Expanded PTZ Control Panel, in the No. box, enter the value of the border that you
want to call.
⚫ Step 2 Click .
⚫ The PTZ camera performs scanning according to the configured borders.
⚫ Step 3 Click again to stop auto scanning.
1.4.4.5 Calling Auto-Pan
⚫ Step 1 On the Expanded PTZ Control Panel, click to start moving in horizontal direction.
⚫ Step 2 Click again to stop moving.
1.4.4.6 Using AUX Button
⚫ On the Expanded PTZ Control Panel, click , the AUX setting interface is displayed. See
Figure 1-91.
⚫ In the Direct Aux list, select the option that corresponds to the applied protocol.
⚫ In the Aux Num box, enter the number that corresponds to the AUX switch on the decoder.
⚫
⚫
⚫
⚫
⚫
To Next Page
Loading...
