Critical Environment Technologies FCS - Test Strobe; Test Relays

© 2021 All rights reserved. Data subject to change without notice. 47
Rev. C | 2021.12 FCS - Installation Manual
7.6.2 Test Strobe
NOTE: Before testing the strobe, warn people in the vicinity of where the strobe will be seen
so it does not cause unnecessary distress or response.
In Test menu (passcode 1), press on Test Strobe.
Enter the length of time you want to test the strobe for. Press Start Test to begin the test.
To cancel the test, go back into the Test menu, open the Test Strobe screen and enter 0 in the
Minutes eld and press Start Test.
To cancel the test, go back into the Test menu, open the Test Strobe screen and enter 0 in the
Minutes eld and press Start Test.
7.6.3 Test Relays
NOTE: Before testing the relays, notify the appropriate people so unnecessary distress or
response is not caused.
In Test menu (passcode 1), press on Test Relays.
Enter the relay number you want to test and enter the length of time you want to test the
relay for. Press Start Test to begin the test.
To cancel the test, go back into the Test menu, open the Test Relays screen and enter 0 in the
Minutes eld and press Start Test.
NOTE: Relay ON and OFF delays do NOT apply in test mode.