Critical Environment Technologies FCS

To Previous Page

FCS20211221-C

Unit 145, 7391 Vantage Way, Delta, BC V4G 1M3 Canada

Tel: +1.604.940.8741 Toll Free: +1.877.940.8741

www.critical-enviroment.com

SAFER AIR EVERYWHERE.

Main Page

Table of Contents3
Policies5
Important Note5
Warranty Policy5
Service Policy6
Copyrights and Registered Trademarks6
Disclaimer7
Revisions7
Introduction8
General Description8
Key Features8
Instrument Specifications9
Technical Specifications9
Maximums by Model11
Enclosure Dimensions12
List of Compatible Devices12
Instrument Features14
Front Exterior Enclosure14
Interior System Layout (Bottom) Shown with Options -AI and AO Installed15
Interior System Layout (Door)16
Optional Internal Analog Inputs and Analog Outputs (Options -AI and -AO)17
Installation18
General Safety Warnings18
Protection against Electrical Risks18
Protection against Mechanical Risks18
Location of System Installation18
Wet Environment Considerations19
EMI and RF Interference Considerations19
Standard Enclosure Mounting Components20
Enclosure Interior Base20
Enclosure Top and Bottom20
Wiring Power Supply Connections21
Wire Gauge Vs Run Length21
Wiring a Remote Power Supply (RPS-24VDC)22
Wiring Internal Analog Outputs (Option -AO)23
Wiring Internal Analog Inputs (Option -AI)25
Wiring LNK-AO Peripheral Device (Additional Analog Outputs)27
Wiring LNK-AI Peripheral Device (Additional Analog Inputs)27
Wiring Digital Inputs (LPT-P and LPT-M Transmitters)28
Wiring LNK-XT Network Extender Peripheral Device Connections29
Wiring to Building Automation System (BAS)30
Wiring Remote Strobe/Horn Using Output Terminal31
Wiring Internal Relay Connections31
Wiring Remote Relay Connections (RLY-4 and RLY-8)32
Wiring RDM Remote Display Connections33
Wired Example of an FCS Gas Detection System35
Basic System Operation36
Navigating the Menu Structure36
Accessing the Menu with Passcodes36
Power up and Warm-Up38
Home Screen Display38
Summary Display (Factory Default)38
Channel, Scrolling Display44
Silencing the Internal Audible Alarm, Terminal Connected And/Or Remote Horns and Strobes44
Test Menu Functions45
Test Audible (Buzzer)46
Test Strobe47
Test Relays47
Test Analog Outputs48
Recalibrating the Display to Improve Response48
Basic Settings and Configurations49
Factory Default Settings49
Set Clock50
Enable / Disable Data Logging and Changing Logging Interval50
How to Clear a Data Logging Failure Fault51
Configure RDM Remote Display(S)52
Enable / Disable Channels53
Enable / Disable Relays, Audible, Horns and Strobes54
Options and Accessories54
Top Mounted Strobe (Option -L)54
Manual Shutoff Switch (Option -SW)55
Enclosure Door Lock and Keys (Option -DL)56
Metal Protective Guard56
Maintenance57
Troubleshooting57

Critical Environment Technologies FCS - Page 60

Table of Contents