Scanshell 800 N The main screen controls
IdScan User Manual version 9.0
©
Card Scanning Solutions, all rights reserved 37
• Category: selection of the scanned document
types, sets the source for data detection accordingly.
• Rotate Image: Rotates the image 90 degrees clockwise. This allows you
to control the image orientation prior to saving.
• Zoom Image: Click to enlarge the image for better reading.
• Scan Image: Starts the image scan if using manual scan and
the image source is set to scanner. Otherwise, activates the File Open dialog.
Note: Opening a file’ is possible only if a scanner is physically connected to the PC, or if
the license key used is a temporary key.
• Toggle Image Source: Sets the input image source to
Scanner (ScanShell 800N or an image file on the hard disk).
• Scanner Connection: A green light indicates that the scanner is
connected to the PC. A red light indicates that no scanner was found.
• Delete Image: Deletes the scanned image. This gives you a
way to control the image prior to saving.
• Save to File: Active only in manual save mode: Opens the
SAVE AS dialog if file saving is enabled, or saves the file to the clipboard.
• Toggle Image Output: Active only in manual save mode: Sets the
output destination to file or clipboard.
• Card Verification: Activates the verification function.
• Toggle reference: Sets the reference source for card
verification purposes.
• Open OCR View: Opens extracted text view.
• Open Configuration Dialog: Opens the configuration dialog screen in
which all the application behavior can be set.
• Exit / End of Scan: Used to close the application or to save the current
image (used in automatic save mode only).
To Next Page
Loading...
