Installation 7
IdScan User Manual version 9.0
©
Card Scanning Solutions, all rights reserved 7
1. GETTING STARTED
BEFORE USING THE SCANNER
The application has been carefully packaged to avoid damage during transportation.
Before operating the scanner, please remove the packaging materials. After removing
the packaging materials, you will find the following:
ScanShell scanner
CD of the application
USB interface cable
User license card
Calibration card (only with ScanShell 800/800N)
MINIMUM SYSTEM REQUIREMENTS
The minimum system requirements are:
• Pentium III with 128MB
• Win 98 Second Edition or higher
• USB port
• 15 MB free storage space
CONNECTING THE SCANNER
The scanner is connected to the computer via the USB port. To connect the reader, do
the following:
Place the scanner on a flat, firm, solid surface with easy access.
Plug the USB interface cable into the USB port of the computer
After the Add new hardware wizard dialog box appears, click Next until you are
asked to set the driver for the reader. You’ll find the driver on the Installation CD
at:
<CD ROM drive>:\Scanner Driver\ScanShell800 (for scanner model
ScanShel800)
<CD ROM drive>:\Scanner Driver\ScanShell800N (for scanner model
ScanShel800N)
<CD ROM drive>:\Scanner Driver\ScanShell1000 (for scanner model
ScanShel1000)
<CD ROM drive>:\Scanner Driver\MagShell900 (for magnetic reader
model MagShel900)
After you specify the driver, click Next until the installation is complete.
To Next Page
Loading...
