CUMMINS ALLISON JetScan iFX i100 - SPEED ADJ (Speed Adjustment)

© 2013 Cummins-Allison Corp.
29
Adjustment Menu Key
Description
DENSITY ADJ
(Density Adjustment)
Prompts the DENSITY ADJUSTMENT screen shown below.
Density levels, or doubles-detection sensitivity, may be set for documents
and the
COUNT
mode. These settings should be adjusted before
processing.
To change density levels:
1. Press  or  to select the desired density setting for a denomination
or document. The first digit in the DENOM column indicates the
denomination. The digit after the decimal indicates the note series.
To view additional density settings, press the
double down arrows
.
2. Use
+
and
–
to select a level (
1
-
5
or
OFF
).
3. Repeat steps 1 and 2 for each document type as needed.
4. When finished, press
EXIT
to return to the ADJUSTMENT MENU.
The lower the number, the less sensitive the setting
is. The higher the number, the more sensitive the
setting is. The ideal sensitivity level depends on
overall document condition.