CUMMINS ALLISON JetScan iFX i100 - Setup Main Menu 2; SBAT ENABLE; STRAPS CLEAR

© 2013 Cummins-Allison Corp.
63
Setup Main Menu 1 Key
Description
COMMUNICATIONS
Pressing
SET
prompts the SELECT DEVICE TO CONFIGURE screen shown
below. Communication ports for up to four external devices, such as a
printer or a computer data communication protocol for external software,
may be configured.
To configure communication port settings for an external device:
1. Press
1
,
2
,
3
or
4
to prompt the following screen:
Radio frequency present.
Install ferrite bead on all external
communication cables; position ferrite
bead near external port.
Only connect Ethernet cable to Ethernet
port.
Use of any other cable may damage
equipment.