CUMMINS ALLISON JetScan iFX i100 User Manual

© 2013 Cummins-Allison Corp.
93
Condition
Action
The machine identified a
hardware problem upon
startup.
The MACHINE START ERROR screen can identify up to three errors at one
time, including:
1. DENSITY SENSOR IS DIRTY, BLOCKED, OR NOT WORKING.
2. CLOSE UPPER TRANSPORT. (See the
Interior Upper-Transport-Plate Diagram.)
3. MACHINE HARDWARE IS NOT CONFIGURED.
4. MACHINE S5 SENSOR IS NOT WORKING.
5. MACHINE IMAGE SENSOR IS NOT READY.
6. ACF BOARD IS NOT RESPONDING.
When these errors appear, machine motors will not run until corrective action is
taken.
OK
can be pressed to remove the error screen and return to the
main screen. However, if corrective action has not been taken and users try to
operate the machine, the MACHINE START ERROR screen will appear again and
the machine’s motors still will not run.
To resolve errors one and two: Perform the required task or maintenance.
To resolve errors three, four, five and six: First try turning the machine
OFF
and
then
ON
. If the error was not resolved,
call a Cummins Allison representative
.
This screen could show
one or several messages.

CUMMINS ALLISON JetScan iFX i100 Specifications

General

Brand	CUMMINS ALLISON
Model	JetScan iFX i100
Category	Bank Note Validator
Language	English