Curtis 1222 - Page 25

Curtis 1222 Manual, os 15
21
2 9 J A N U A R Y 2 0 1 3 D R A F T
2 = Sin/Cos Sensor command, where Analog 1 and Analog 3 inputs
are connected to a sine-cosine transducer. The transducer could
be mounted to a steering wheel or a tiller arm. The sensor may
be set up as either an absolute or relative position device, using
the Absolute Mode parameter (see page 26).
When this steering command is used, sine and cosine
channels are both required (and together serve as the primary
and supervisory devices).
NAME PIN FUNCTION
Analog 1 8 Sine input (Command Analog 1)
Analog 3 19 Cosine input (Command Analog 3)
INPUT DEVICE PARAMETER, cont’d
3 — PROGRAMMABLE PARAMETERS: Command Input Parameters
3 = Sawtooth Sensor command, where Analog 1 and Analog 3 inputs
are connected to a sawtooth transducer. The transducer could
be mounted to a steering wheel or a tiller arm. The sensor may
be set up as either an absolute or relative position device, using
the Absolute Mode parameter (see page 28).
When this steering command is used, primary sawtooth and
offset sawtooth channels are both required (and together serve
as the primary and supervisory devices).
NAME PIN FUNCTION
Analog 1 8 Primary sawtooth input (Command Analog 1)
Analog 3 19 Offset sawtooth input (Command Analog 3)