Curtis 1222 - Fig. 5: Command Input Device 1 Signal Flow

Curtis 1222 Manual, os 15
25
2 9 J A N U A R Y 2 0 1 3 D R A F T
3 — PROGRAMMABLE PARAMETERS: Command Input Parameters
COMMAND INPUT DEVICE 1 – ENCODER1 and 2
ALLOWABLE
PARAMETER RANGE DESCRIPTION
Left Stop to Center -32768 – 0
• n
Defines the total steer command encoder counts to produce a steer
0x4094 0x00 -32768 – 0 command from the center position (Steer Command = 0% = 0°) to
the full left position (Steer Command = -100% = Left Stop).
Left Stop to Center is always a negative number.
Right Stop to Center 0 – 32767
• n
Defines the total steer command encoder counts to produce a steer
0x406D 0x00 0 – 32767 command from the center position (Steer Command = 0% = 0°) to
the full right position (Steer Command = 100% = Right Stop).
Right Stop to Center is always a positive number.
Swap Encoder1 Direction On / Off
• n
Changes the direction (left or right) of the Encoder 1 steer command
0x406C 0x00 On / Off input.
Swap Encoder2 Direction On / Off
• n
Changes the direction (left or right) of the Encoder 2 steer command
0x4069 0x00 On / Off input.
Fig. 5 Command Input Device “1” signal flow (Encoder 1 shown; Encoder 2 is similar).
PCF RIS