Curtis 1297 User Manual

Curtis PMC 1297 Manual
58
commanded to so, and that it has not welded closed. These checks are not
performed if the main contactor diagnostics parameter is set to Off. The main
contactor driver, however, is always protected from overcurrents, short circuits,
and overheating.
MUX ENABLE
The multiplexer enable parameter, when programmed On, enables the J2
connector—and thus the multiplexer—as shown in Figure 4, page 10. When
the multiplexer parameter is programmed Off, the J2 connector is inactive.
3 C — PROGRAMMABLE SHARED PARAMETERS: Multiplexer
Multiplexer Parameter

Curtis 1297 Specifications

General

Brand	Curtis
Model	1297
Category	Controller
Language	English