60 EZ-USB Development Kit User Guide, Doc. # 001-66390 Rev. *D
USB PC Host Utilities and SuiteUSB Applications
■ Firmware Download: After connecting the EZ-USB development board in the NO EEPROM
mode (switch SW2 on board to NO EEPROM), the firmware can be download to RAM, small
EEPROM or the large EEPROM.The procedure to download is explained in EZ-USB Develop-
ment Kit Firmware Examples chapter on page 65 for each of the firmware examples provided
with the kit.
■ Script file generation and automatic firmware download: This utility can be used to generate
the script file for a relevant firmware .hex file and later use the script file to automatically down-
load the firmware using the script. The process of automatic firmware download using scripts is
explained in the section Script Generation and Play using CyControlCenter on page 49.
■ Data transfers: Using the tool, the USB packet data can be transferred over an endpoint. The
procedure is explained in the CyControlCenter.pdf file located at C:\Cypress\Cypress Suite
USB 3.4.7\CyUSB.NET\.
7.2.3 Streamer Utility
The Streamer utilities are available in both C++ and C#.NET framework versions. These utilities are
used to test the Bulk and Isochronous data transfer throughput in both IN and OUT directions.
■ Download the cystream.hex file located at C:\Cypress\Cypress Suite USB
3.4.7\Firmware\CyStreamer using CyConsole or CyControlCenter. The procedure to down-
load the firmware to RAM memory is explained in Method to Download Firmware Image to EZ-
USB Internal RAM Memory on page 69
■ Open anyone of the Streamer applications at the following locations:
1. Streamer using C++ CYAPI.lib: For 32-bit Windows OS platforms, the utility is located at
C:\Cypress\Cypress Suite USB 3.4.7\CyAPI\examples\Streamer\x86\Release. For 64-bit OS
platforms, refer to C:\Cypress\Cypress Suite USB 3.4.7\CyAPI\exam-
ples\Streamer\x64\Release
To Next Page
Loading...
