DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
3
COMMAND SYNTAX
The following symbols are used to describe how command entries are made and values and arguments are specified in this
manual. The online help contained in the CLI and available through the console interface uses the same syntax.
Note: All commands are case-sensitive. Be sure to disable Caps Lock or
any other unwanted function that changes text case.
<angle brackets>
Purpose Encloses a variable or value that must be specified.
Syntax
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan
<vlan_name 32> | state [enable | disable]} | bootp | dhcp
Description In the above syntax example, you must supply an IP interface name in the
<ipif_name> space, a VLAN name in the <vlan_name 32> space, and the
network address in the <network_address> space. Do not type the angle
brackets.
Example
Command
config ipif System ipaddress 10.24.22.5/255.0.0.0 vlan Design state
enable
[square brackets]
Purpose Encloses a required value or set of required arguments. One value or
argument can be specified.
Syntax
create account [admin | user]
Description
In the above syntax example, you must specify either an admin or a user
level account to be created. Do not type the square brackets.
Example
Command
create account admin
| vertical bar
Purpose Separates two or more mutually exclusive items in a list, one of which must
be entered.
Syntax
show multicast_fdb {vlan <vlan_name 32> | mac_address <macaddr>}
Description
In the above syntax example, you must specify either a VLAN, or a MAC
address by which to show multicast FDB entries. Do not type the vertical
bar.
Example
Command
show snmp community
9
To Next Page
Loading...
