D-Link DES-3010G - Config Radius; Show Radius; To Configure RADIUS Settings

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
DES-3026:4#config radius delete 1
DES-3026:4#
Command: config radius delete 1
Success.
config radius
Purpose Used to configure the Switch’s RADIUS settings.
Syntax
config radius <server_index 1-3> {ipaddress <server_ip> | key
<passwd 32> | auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}
Description
The config radius command is used to configure the Switch’s RADIUS
settings.
Parameters
<server_index 1-3> − Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be entered
on the Switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between
the Switch and the RADIUS server.
default − Returns all of the ports in the range to their default RADIUS
settings.
auth_port <udp_port_number 1-65535> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for
accounting requests. The default is 1813.
Restrictions Only administrator-level users can issue this command.
 <passwd 32> − The shared-secret key used by the RADIUS server
and the Switch. Up to 32 characters can be used.
Example usage:
To configure RADIUS settings:
DES-3026:4#config radius 1 10.48.74.121 key dlink default
Command: config radius 1 10.48.74.121 key dlink default
Success.
DES-3026:4#
show radius
Purpose Used to display the current RADIUS configurations on the Switch.
Syntax
show radius
Description The show radius command is used to display the current RADIUS
configurations on the Switch.
Parameters None.
Restrictions None.
118