D-Link DES-3010G - To Create an 802.1 X User; Show 802.1 X User; To Display RADIUS Settings on the Switch; Create 802.1 X User

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
Example usage:
To display RADIUS settings on the Switch:
DES-3026:4#show radius
Command: show radius
Index IP Address Auth-Port Acct-Port Status Key
Number Number
----- ------------------ --------- --------- ----------- ------------
1 10.1.1.1 1812 1813 Active switch
2 20.1.1.1 1800 1813 Active des3226
3 30.1.1.1 1812 1813 Active dlink
Total Entries : 3
DES-3026:4#
create 802.1x user
Purpose Used to create a new 802.1x user.
Syntax
create 802.1x user <username 15>
Description
The create 802.1x user command is used to create new 802.1x
users.
Parameters
<username 15> − A username of up to 15 alphanumeric characters
in length.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To create an 802.1x user:
DES-3026:4#create 802.1x user dtremblett
Command: create 802.1x user dtremblett
Enter a case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DES-3026:4#
show 802.1x user
Purpose Used to display the 802.1x user accounts on the Switch.
Syntax
show 802.1x user
Description
The show 802.1x user command is used to display the 802.1x
Port-based or MAC-based Network Access control local users
currently configured on the Switch.
Parameters None.
Restrictions None.
Example usage:
119