D-Link DES-3010G - To Display All of the Commands in the CLI; Command History List

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
25
COMMAND HISTORY LIST
The command history list commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
dir
config command_history <value 1-40>
Parameters
?
show command_history
Each command is listed, in detail, in the following sections.
?
Purpose Used to display all commands in the Command Line Interface (CLI).
Syntax
? {<command>}
Description This command will display all of the commands available through the
Command Line Interface (CLI).
Parameters <command> - Entering the question mark with an appropriate command
will list all the corresponding parameters for the specified command, along
with a brief description of the commands function and similar commands
having the same words in the command.
Restrictions None.
Example usage
?
clear arptable
To display all of the commands in the CLI:
DES-3026:4#?
Command: ?
..
clear
clear counters
clear fdb
clear log
config 802.1p default_priority
config 802.1p user_priority
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x capability ports
config 802.1x init
config 802.1x reauth
config account
config arp_aging time
config arpentry
config command history
config dst
config fdb_aging_time minutes
config gvrp
config igmp snooping
140