D-Link DES-3010G - To Enable the SNTP Function; Show Sntp; To Display SNTP Configuration Information; Enable Sntp

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
DES-3026:4#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DES-3026:4#
show sntp
Purpose Used to display the SNTP information.
Syntax
show sntp
Description This command will display SNTP settings information including the
source IP address, time and poll interval.
Parameters None.
Only administrator-level users can issue this command. Restrictions
Example usage:
To display SNTP configuration information:
DES-3026:4#show sntp
Command: show sntp
Current Time Source : System Clock
SNTP : Enabled
SNTP Primary Server : 10.1.1.1
SNTP Secondary Server : 10.1.1.2
SNTP Poll Interval : 30 sec
DES-3026:4#
enable sntp
Purpose Enables SNTP server support.
Syntax
enable sntp
Description This will enable SNTP support. SNTP service must be separately
configured (see config sntp). Enabling and configuring SNTP support will
override any manually configured system time settings.
Parameters None.
Restrictions Only administrator-level users can issue this command. SNTP settings
must be configured for SNTP to function (config sntp).
Example usage:
To enable the SNTP function:
DES-3026:4#enable sntp
Command: enable sntp
Success.
DES-3026:4#
125