D-Link DES-3010G - To Display the Current Authentication Diagnostics for Port 16; Show Auth_Session_Statistics; Show Auth_Diagnostics

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
radiusAuthClientUnknownTypes 0
radiusAuthClientPacketsDropped 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_diagnostics
Purpose Used to display the current authentication diagnostics.
Syntax
show auth_diagnostics {ports [<portlist>}
Description
The show auth_diagnostics command is used to display the
current authentication diagnostics of the Switch on a per port basis.
Parameters
ports <portlist> − Specifies a port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the current authentication diagnostics for port 16:
DES-3026:4#show auth_diagnostics ports 1
Command: show auth_diagnostics ports 1
Port number : 1
EntersConnecting 0
EapLogoffsWhileConnecting 0
EntersAuthenticating 0
BackendResponses 0
BackendNonNakResponsesFromSupplicant 0
BackendAuthFails 0
SuccessWhileAuthenticating 0
TimeoutsWhileAuthenticating 0
FailWhileAuthenticating 0
ReauthsWhileAuthenticating 0
EapStartsWhileAuthenticating 0
EapLogoffWhileAuthenticating 0
ReauthsWhileAuthenticated 0
EapStartsWhileAuthenticated 0
EapLogoffWhileAuthenticated 0
BackendAccessChallenges 0
BackendOtherRequestsToSupplicant 0
BackendAuthSuccesses 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_session_statistics
Used to display the current authentication session statistics.
Syntax
show auth_session_statistics {ports [<portlist> | all]}
Description
The show auth_session statistics command is used to display
the current authentication session statistics of the Switch on a
per port basis.
Parameters
ports <portlist> − Specifies a port or range of ports to be viewed.
all – Specifies that all ports will be viewed.
Restrictions None.
Purpose
122