DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
RMON : Disabled
DES-3026:4#
show config
Purpose Used to display a list of configuration commands entered into the
Switch.
Syntax
show config [dram | flash]
Description This command displays a list of configuration commands entered
into the Switch.
Parameters dram – Entering this parameter will display configurations saved to
the DRAM memory in the Switch.
flash - Entering this parameter will display configurations saved to
the flash memory of the switch.
Restrictions None.
Example usage:
To view configurations entered on the Switch that were saved to the DRAM:
DES-3026:4# show config dram
Command: show config dram
# BASIC
config serial_port baud_rate 115200 auto_logout never
enable telnet 23
enable web 80
enable clipaging
# STORM
config traffic control 1-16 broadcast disable multicast disable dlf disable
threshold 128
config traffic control 1-16 broadcast disable multicast disable dlf disable
threshold 128
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
show serial_port
Purpose Used to display the current serial port settings.
Syntax
show serial_port
Description This command displays the current serial port settings.
Parameters None.
Restrictions None.
Example usage:
To display the serial port setting:
15
To Next Page
Loading...
