D-Link DES-3010G - To Display the Status of STP on the Switch; Disable Stp; To Disable STP on the Switch; Show Stp

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
disable stp
Purpose Used to globally disable STP on the Switch.
Syntax
disable stp
Description This command allows the Spanning Tree Protocol to be globally
disabled on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable STP on the Switch:
DES-3026:4#disable stp
Command: disable stp
Success.
DES-3026:4#
show stp
Purpose Used to display the Switch’s current STP configuration.
Syntax
show stp
Description This command displays the Switch’s current STP configuration.
Parameters None.
Restrictions None.
Example usage:
To display the status of STP on the Switch:
Status 1: STP enabled with STP compatible version
DES-3026:4#show stp
Command: show stp
Bridge Parameters Settings
STP Status : Enabled
Max Age : 20
Hello Time : 2
Forward Delay : 15
Priority : 32768
STP Version : STP compatible
TX Hold Count : 3
Forwarding BPDU : Enabled
Bridge Current Status
Designated Root Bridge : 00-00-51-43-70-00
Root Priority : 32768
Cost to Root : 200000
Root Port : 10
Last Topology Change : 53sec
Topology Changes Count : 1
Protocol Specification : 3
64